Image may be NSFW.
Clik here to view.
Hello guys.
If you’re like me I was always looking to find the best solution for a charging station for all the gadgets and tools around the house.
I would like to share with you & the world my version of a simple charging station that is low cost and simple to make. No drilling required, easy to put on any surface & most important “instant” to make.
I present to you SAMLA Instant charging station.
Hope you’ll like it
Step 1: Requirements
Things you’ll need to make your instant charging station:- SAMLA BOX
- SAMLA INSERT
- Power strip
- Velcro squares
Clik here to view.

Photo: IKEA.com
Clik here to view.

Photo: IKEA.com
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Step 2: Inserting Power Strip
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Insert power strip through SAMLA INSERT handle.
Step 3: Use Velcro
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
After inserting the power strip cable through the handle stick 2 Velcro squares on the back of your Power strip.(Hint: use both the male & female velcro so you’ll have double sticky back that will be helpful for the next step)
Step 4: Position The Power Strip
Image may be NSFW.
Clik here to view.
Position and stick your power strip inside the SAMLA box.
Step 5: The End
Image may be NSFW.
Clik here to view.
Insert the SAMLA INSERT inside the box & pull your cable gently.That’s it. Very simple & not a single mess.
Now put your chargers & be creative.
I appreciate your comments.
Thanks.
Step 6: Here Is My SAMLA
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
To keep it away from children’s reach, I’ve installed it in my kitchen with the help of two BLECKA hooks that were on the wall already.
The post SAMLA Charging Station appeared first on IKEA Hackers.